Table of Contents
Advertisement
Chapter 7: Configuring VLANs on the SSR
Changing a Protocol-Based VLAN's Name, ID, or Protocol Binding
To modify the name, ID, or protocol binding of a protocol-based VLAN:
1.
Start Configuration Expert if you have not already done so.
Note:
2.
Open the configuration file you want to modify and then double-click that file's
Bridging Configuration object.
3.
Double-click the VLAN Configuration object.
4.
Double-click the Protocol-Based VLANs object. From the list of VLANs that appears,
click the VLAN you want to modify.
A VLAN Definition dialog box similar to the following appears:
5.
If you want to change the VLAN's name or ID, edit the appropriate text boxes.
6.
If you want to change which protocols the VLAN supports, select and clear the
appropriate check boxes.
7.
Click OK.
102
If you start Configuration Expert from the Schematic view choosing the
Configure VLAN command, Configuration Expert automatically expands
the Active Configuration file's tree to the VLAN Configuration object. If you
are adding a VLAN to the Active Configuration file, go to
Figure 49. VLAN Definition dialog box (protocol-based)
step
3.
CoreWatch User's Manual
Advertisement
Table of Contents
