Table of Contents
Advertisement
then the router ID is set to the address of the first interface which is in the up state that
the SSR encounters. The address of a non-point-to-point interface is preferred over the
local address of a point-to-point interface.
8.
Click OK.
Defining Static ARP Entries
ARP maps network addresses to MAC addresses. Define static ARP entries if you want
the SSR to use those entries rather than using ARP to automatically resolve host and MAC
address entries.
To define static ARP entries:
1.
Start Configuration Expert if you have not already done so.
2.
Open the configuration file you want to modify and then double-click that file's
Routing Configuration object.
3.
Double-click the IP Routing Configuration object.
4.
Double-click the Static ARP Entries object. Then click the New ARP Node object.
Configuration Expert opens the ARP wizard.
5.
Click Next.
CoreWatch User's Manual
Chapter 9: Configuring Unicast Routing on the SSR
Figure 76. ARP wizard
133
Advertisement
Table of Contents
