Table of Contents
Advertisement
After you finish defining all of an ACL's rules, Configuration Expert adds the ACL to the
IPX ACLs object. Configuration Expert also adds a separate object for each rule and places
this list of rules in the ACL object.
The rule numbers displayed in an ACL's list of rules, are automatically assigned by
Configuration Expert. A rule's number is included in the Rule # box of the IPX ACL Rule
panel when you are defining that rule.
Setting Up IPX RIP Filters
Set up IPX RIP filters to permit or deny IPX RIP network advertisements. You set up such
filters by configuring an ACL for IPX RIP interfaces. To do so, take the following steps:
1.
Start Configuration Expert if you have not already done so.
2.
Open the configuration file you want to modify and then double-click that file's
Security Configuration object.
3.
Double-click the IPX Security object.
4.
Click the Configure New IPX Security Profile object.
Configuration Expert opens the IPX Security wizard.
5.
Click Next.
Configuration Expert prompts you for the ACL's name.
CoreWatch User's Manual
Figure 136. IPX Security wizard (RIP)
Chapter 13: Configuring Security on the SSR
217
Advertisement
Table of Contents
