Table of Contents
Advertisement
Configuration Expert adds the new interface to those found in the IPX interfaces
bound to Ports object.
Note:
Creating IPX Interfaces Bound to a VLAN
If you have created an IPX VLAN, you can bind that VLAN to an IPX interface while
creating the interface. To create an IPX interface that will be bound to an existing VLAN:
1.
Start Configuration Expert if you have not already done so.
2.
Open the configuration file you want to modify and then double-click that file's
Routing Configuration object.
3.
Double-click the IPX Routing Configuration object.
4.
Double-click the IPX Interface Configuration object. Then click the Configure New
IPX Interface object.
Configuration Expert opens the IPX Interface wizard.
5.
Click Next.
CoreWatch User's Manual
When you apply an ACL to an interface, the SSR appends an implicit
deny rule to that ACL. The implicit deny rule denies all traffic. If you
intend to allow all traffic that does not match your specified ACL rules to
go through, you must explicitly define a rule to permit all traffic. To do so,
make sure the last rule of the ACL permits all traffic.
Figure 95. IPX Interface wizard (VLAN)
Chapter 11: Configuring the SSR for IPX Routes
167
Advertisement
Table of Contents
