Port=<Name>:<Rate>,<Parity>,<Data Bits>,<Stop Bits - Cabletron Systems CBU-NM User Manual

CBU-NM
User Manual
7.7 Settings
In this chapter, the syntax, default value, and purpose of each setting
appear in the following format:
SettingName=<value>
Default: The default value for this setting. This value is used if the
setting is not present in your PCNC.INI file, or if the specified
value is invalid.
Purpose: The function of the setting and its valid options.
Some settings will only take a certain range of integers, between a
pre-defined maximum and minimum value. If you enter a value that is
too high, PCNC will use the maximum value. If you enter one that is too
low, PCNC will use the minimum value. The range for each setting is
indicated where appropriate in the following sections and in the on-line
help.
7.8 [Control Link]
All settings in this section are required for PCNC to connect to Local
devices. If you have no Local devices to connect, no settings other than
Port are required. In this case, no other options in this section have any
effect, and do not need to appear in the file. However, you can still keep
the settings in the file for reference if you are likely to reinstate the
Control Link in the future.
7.8.1 Port=<name>:<rate>,<parity>,<data bits>,<stop bits>
Default: None
Purpose: Specifies the COM port used for the Control Link. If None is
specified, the Link is disabled. You should disable the Link if
you have no local devices to connect to PCNC.
The recommended setting is Port=COMx:9600,n,8,1 .
ii 7–4 80-60100000-02