Chapter 8: Configuring IP Interfaces for the SSR
Creating IP Interfaces Bound to a VLAN
If you have created an IP VLAN, you can bind that VLAN to an IP interface while creating
the interface. To create an IP interface that will be bound to an existing VLAN:
1.
Start Configuration Expert if you have not already done so.
2.
Open the configuration file you want to modify and then double-click that file's
Routing Configuration object.
3.
Double-click the IP Routing Configuration object.
4.
Double-click the IP Interface Configuration object and then click the Configure New
IP interface object.
Configuration Expert opens the IP Interface wizard.
5.
Click Next.
An IP Interface Definition panel similar to the following appears:
116
go through, you must explicitly define a rule to permit all traffic. To do so,
make sure the last rule of the ACL permits all traffic.
Figure 58. IP Interface wizard (VLAN)
CoreWatch User's Manual