Table of Contents
Advertisement
Chapter 16: Configuring Routing Policies on the SSR
Setting RIP Routing Policy Defaults
To set default values for RIP's metric and preference that will be used for RIP across all
routing policies:
1.
Start Configuration Expert if you have not already done so.
2.
Open the configuration file you want to modify and then double-click that file's
Routing Configuration object.
3.
Double-click the IP Routing Configuration object.
4.
Double-click the IP Unicast Routing object.
5.
Double-click the Routing Policy Configuration object.
6.
Double-click the Global Default Parameters object and click the RIP Defaults object.
A RIP Policy Defaults dialog box similar to the following appears:
Note:
7.
Assign a preference for the routes learned by RIP. To do so, enter a number from 0 to
255 in the Default Route Preference box.
298
Figure 194. RIP Policy Defaults dialog box
You can specify values for the default route preference and default metric in
the RIP Policy Defaults dialog box just as in the RIP Global Parameters
dialog box. If you change a parameter in one dialog box, that change is
automatically applied to the other dialog box. See
Parameters" on page 139
for more information.
"Setting RIP Global
CoreWatch User's Manual
Advertisement
Table of Contents
