Table of Contents
Advertisement
The preference you specify applies to all IP RIP interfaces on the SSR. The default value
for route preference is 100.
8.
Set the metric for routes advertised through RIP by entering a number from 1 to 16 in
the Default Metric box.
Note:
9.
Click OK.
Setting OSPF Routing Policy Defaults
To set default values for OSPF's metric and preference that will be used for OSPF across all
routing policies:
1.
Start Configuration Expert if you have not already done so.
2.
Open the configuration file you want to modify and then double-click that file's
Routing Configuration object.
3.
Double-click the IP Routing Configuration object.
4.
Double-click the IP Unicast Routing object.
5.
Double-click the Routing Policy Configuration object.
6.
Double-click the Global Default Parameters object and click the OSPF Defaults object.
CoreWatch User's Manual
The metric 16 (the default) is equivalent in RIP to infinite and makes a route
unreachable. You must set the default metric to a value other than 16 in order
to allow the SSR to export routes from other protocols such as OSPF into RIP.
Chapter 16: Configuring Routing Policies on the SSR
299
Advertisement
Table of Contents
