Table of Contents
Advertisement
7.
Bind the entry to a port that the host is connected to by doing the following:
a.
In the Available Port list, double-click the module containing the desired port.
From the list of available ports that appears, select the port that you want to bind
to the entry.
b. Click the Add button.
Note:
If you accidentally add the wrong port, remove the port by selecting it from the
Selected Port list and then clicking the Remove button.
8.
Click Finish.
Defining Static Route Entries
Static route entries specify routes you want to explicitly configure and enter into the SSR's
routing table. Define static route entries if you want to configure static routes used by the
unicast routing protocol process. These routes may be overridden by routes with better
preference. To define static route entries:
1.
Start Configuration Expert if you have not already done so.
2.
Open the configuration file you want to modify and then double-click that file's
Routing Configuration object.
3.
Double-click the IP Routing Configuration object.
4.
Double-click the Static IP Routes object. Then click the Create New IP Static Route
Entry object.
An IP Static Route Definition dialog box similar to the following appears:
CoreWatch User's Manual
You can bind only a single port to an entry.
Chapter 9: Configuring Unicast Routing on the SSR
135
Advertisement
Table of Contents
