Disabling Stp On A Port - Cabletron Systems SSR-GLX19-02 User Manual

Note:
6. Click the Add button.
Configuration Expert moves the selected port from the STP Disabled Ports list to the
corresponding module in the STP Enabled Ports list.
7. Click OK.
Configuration Expert adds the port to those found in the STP Enabled Ports object,
which is located in the STP Port State object.

Disabling STP on a Port

Disable STP on a port if the port does not need to participate in STP. To disable STP on a
port:
1. Start Configuration Expert if you have not already done so.
2. Open the configuration file you want to modify and then double-click that file's
Bridging Configuration object.
3. Double-click the Spanning Tree Protocol object.
4. In the list of STP objects that appears, select the STP Port State object.
A Bridging STP dialog box similar to the following appears:
CoreWatch User's Manual
Clicking a module in the STP Disabled Ports list rather than double-clicking
it selects all of the module's ports on which STP is currently disabled. Use this
method if you want to enable STP on all of those ports.
Figure 33. Bridging STP dialog box (disabling STP)
Chapter 6: Configuring SSR Bridging
81