Table of Contents
Advertisement
Chapter 10: Configuring Multicast Routing on the SSR
2.
Open the configuration file you want to modify and then double-click that file's
Routing Configuration object.
3.
Double-click the IP Routing Configuration object.
4.
Double-click the IP Multicast Routing object. Then double-click the IGMP Protocol
object and click the IGMP Global Parameters object.
An IGMP Global Parameters Configuration dialog box similar to the following
appears:
5.
In the Query Timer box, specify how often the SSR sends packets to learn which hosts
are available.
You specify the interval in seconds and can enter values from 10 to 3600 in increments
of 5 (that is, 5, 10, 15, and so on). The default is 125 seconds.
6.
In the Response Timer box, specify how long the SSR waits for hosts to respond to the
host-membership queries it sends.
7.
Click OK.
The entries you make in the IGMP Global Parameters dialog box will apply to all ports.
Enabling or Disabling IGMP on Interfaces
You can enable or disable IGMP on the SSR's IP interfaces. To enable or disable IGMP
interfaces:
156
Figure 86. IGMP Global Parameters Configuration dialog box
CoreWatch User's Manual
Advertisement
Table of Contents
