Table of Contents
Advertisement
Configuring a Port for Flow-Based Bridging
To configure a port for flow-based bridging:
1.
Start Configuration Expert if you have not already done so.
2.
Open the configuration file you want to modify and then double-click that file's
Bridging Configuration object.
3.
Double-click the Bridging Mode object.
A Bridging Mode dialog box similar to the following appears:
4.
In the Address Mode list, double-click the module on which the port you want to
configure is located. Configuration Expert displays the module's ports that are
currently using address-based bridging. From the list of ports that appears, select the
port that you want to configure.
CoreWatch User's Manual
Figure 24. Bridging Mode dialog box (flow-based bridging)
Chapter 6: Configuring SSR Bridging
67
Advertisement
Table of Contents
