Configuring Igmp Snooping On Vlans - Dell PowerConnect 8024 User Configuration Manual

Command
ip igmp snooping
mrouter-time-out
out
CTRL + Z
show ip igmp snooping
show ip igmp snooping
interface
interface

Configuring IGMP Snooping on VLANs

Beginning in Privileged EXEC mode, use the following commands to
configure IGMP snooping settings on VLANs.
Command
configure
vlan database
ip igmp snooping
ip igmp snooping
groupmembership-
vlan-id seconds
interval
ip igmp snooping
vlan-id
maxresponse
seconds
ip igmp snooping fast-
vlan-id
leave
728
Configuring L2 Multicast Features
Purpose
Specify the multicast router time-out value for an
time-
interface. This command sets the number of seconds to
wait to age out an automatically-learned multicast router
port.
Exit to Privileged EXEC mode.
View IGMP snooping settings configured on the switch.
View the IGMP snooping settings for a specific port or
LAG.
Purpose
Enter global configuration mode.
Enter VLAN Configuration mode.
vlan-id
Enable IGMP snooping on the specified VLAN.
Specify the host time-out value for the specified VLAN. If
an IGMP report for a multicast group is not received in
the number of seconds specified by the
VLAN is deleted from the member list of that multicast
group.
Specify the leave time-out value for the VLAN. If an
IGMP report for a multicast group is not received within
the number of seconds configured with this command
after an IGMP leave was received from a specific interface,
the current VLAN is deleted from the member list of that
multicast group.
Enables IGMP snooping fast-leave mode on the specified
VLAN. Enabling fast-leave allows the switch to
immediately remove the layer 2 LAN interface from its
forwarding table entry upon receiving an IGMP leave
message for that multicast group without first sending out
MAC-based general queries to the interface.
seconds
value, this