d. Proceed to step 5.
A
Figure 79. Installing Power and SATA Cables (Active Midplane Installed)
Note: You will not use the long SATA cable from the 6th HDD kit in a system with an active
midplane.
OR
If you have a passive midplane installed in your system, do the following:
a. Install one end of the power cable to the power connector on the backplane and
b. Install one end of the long SATA cable (labeled HSBP/TAPE) to the sixth HDD
c. Connect the other end of the cable (labeled SERVER BOARD) to the SATA5
®
Intel
Server System SR2600UR/SR2625UR Service Guide
B
the opposite end to the power connector on the sixth HDD board (see letter "A"
in
Figure
80).
board (see letter "B" in
letter "C" in
Figure
80).
connector on the server board (see letter "D" in
Figure
80) and route the cable through the air baffle (see
Figure
80).
AF003033
89