a. Connect the hard drive SATA cables from either the server board or the add-in
A
b. If you connect the SATA cables from the passive midplane to the add-in card,
Note: Do NOT connect the HBA cable in a system with an active midplane or when
6. Install the fan module. For instructions, see
page
7. Install the bridge board as follows:
a. Open the retention clips on both ends (see letter "A" in
b. Slide the bridge board through the fan assembly (see letter "B" in
c. Insert the bridge board into the bridge board connector on the midplane and
106
card to the corresponding SATA connectors on the midplane board.
Figure 99. Installing the SATA Cables
also install the 3-pin white cable between the HBA connector on the midplane
and the add-in card to enable fault LED control.
using the SATA connectors on the server board to connect the hard drive SATA
cables.
127.
server board (see letter "C" in
"Replacing a Fan Module" on
Figure
100).
®
Intel
Server System SR2600UR/SR2625UR Service Guide
B
AF003071
Figure
100).
Figure
100).