Installing And Removing A Pci Add-In Card; Installing A Pci Add-In Card; Figure 36. Installing A Full-Height Add-In Card - Intel SR2600UR - Server System - 0 MB RAM Service Manual

10. Connect any cables to add-in cards that require them. See your add-in card
documentation for information and add-in card requirements.

Installing and Removing a PCI Add-in Card

The following sections describe how to install and remove a PCI add-in card.

Installing a PCI Add-in Card

To install a PCI add-in card, follow these steps:
1. Remove the PCI riser assembly. For instructions, see
Assembly" on page
2. Open the rear retention clip by pushing the blue slide upward and rotating clip to
the fully open position (see letter "A" in
3. Open the front retention clip by pushing the blue latch in the direction shown and
rotating 90 degrees outward (see letter "B" in
4. Remove the filler panel from the selected add-in card slot (see letter "C" in
Figure
5. Insert add-in card until it seats in riser card connector (see letter "D" in
B
6. Close the rear retention clip. Push the blue slide upward and press the clip to lock it
into place.
7. Close the front retention clip and push the blue latch forward to lock it into place.
Note: Make sure that all empty add-in card slots have filler panels installed.
54
50.
36).

Figure 36. Installing a Full-height Add-In Card

Intel
"Removing the PCI Riser
Figure 36).
Figure 36).
C
D
®
Server System SR2600UR/SR2625UR Service Guide
Figure 36).
A
AF002969