Figure 59. Removing Hot-Swap Disk Carrier From The Server System; Figure 60. Removing Drive Blank From Drive Carrier - Intel SR2600UR - Server System - 0 MB RAM Service Manual

1. Press in on the green latch (at the front of the hard drive carrier) to release the
carrier (see letter "A" in
2. Pull out on the black lever and slide the carrier out from the server system (see
letter "B" in
3. Remove the four screws securing the plastic retention device to the carrier (see
letter "A" in
Figure
4. Remove the hard drive from its wrapper and place it on an anti-static surface.
5. Set any jumpers and/or switches on the drive according to the drive manufacturer's
instructions.
6. With the drive circuit-side down, position the connector end of the drive so that it is
facing the rear of the drive carrier.
7. Align the holes in the drive to the holes in the drive carrier and attach it to the
carrier using the four screws that were attached to the plastic retention device (see
letter "B" in
®
Intel Server System SR2600UR/SR2625UR Service Guide
Figure
Figure 59).
A

Figure 59. Removing Hot-swap Disk Carrier from the Server System

Figure 60) and remove the retention device (see letter "B" in
60) . Store the retention device for future use.

Figure 60. Removing Drive Blank from Drive Carrier

Figure 61).
59).
B
AF002986
B
AF002987
A
75