6. First fit the front of the module into the back panel slot(s), and then attach the
module to the server board connector and engage the standoffs (see letter "C" in
Figure
7. Install the processor air duct. For instructions, see
Duct" on page
8. Install the PCI riser assembly into the server system. For instructions, see
"Installing the PCI Riser Assembly" on page
Removing the I/O Expansion Module
To remove the I/O expansion module, follow these steps:
1. Remove the PCI riser assembly. For instructions, see
Assembly" on page
2. Remove the processor air duct. For instructions, see
Duct" on page
3. Disconnect the I/O expansion module from the server board connector and the
standoffs and remove the module out of the server system (see letter "A" in
Figure
4. Remove the standoffs from the server board (see letter "B" in
®
Intel
Server System SR2600UR/SR2625UR Service Guide
88).
Snap
Standoff
B
Standoff
Hole
Figure 88. Installing the I/O Expansion Module to the Server System
57.
50.
56.
89.
A
C
Server Board
Filler Panels
I/O Connector 1
51.
AF003006
"Installing the Processor Air
"Removing the PCI Riser
"Removing the Processor Air
Figure
89).
97