Configuring A Serial Connection - Cisco ROUTER-SDM-CD User Manual

Configuring a Serial Connection

Table 5-5 Advanced Options Fields
Element
Default Static Route
Next Hop Address
Port Address Translation
Inside Interface to be Translated Choose the inside interface connected to the network whose host IP
Configuring a Serial Connection
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Cisco Router and Security Device Manager 2.5 User's Guide
5-6
Description
Check this box if you want to configure a static route to the outside
interface to which outgoing traffic will be routed. If a static route
has already been configured on this router, this box does not appear.
If your service provider has given you a next-hop IP address to use,
enter the IP address in this field. If you leave this field blank, Cisco
SDM will use the WAN interface that you are configuring as the
next-hop interface.
If devices on the LAN have private addresses, you can allow them
to share a single public IP address. You can ensure that traffic goes
to its proper destination by using PAT, which represents hosts on a
LAN with a single IP address and uses different port numbers to
distinguish the hosts. If PAT has already been configured on an
interface, the PAT option will not be visible.
addresses you want to be translated.
Complete these steps to configure a Serial connection:
If you want to review the IOS CLI commands that you send to the router when
you complete the configuration, go to the Cisco SDM toolbar, and click Edit >
Preferences > Preview commands before delivering to router.
In the Cisco SDM toolbar, click Configure.
In the Cisco SDM taskbar, click Interfaces and Connections.
In the Create Connection tab, click Serial.
Click Create Connection to start the wizard. The wizard Welcome screen
describes the tasks you will complete.
Click Next to go to the subsequent screens to configure the connection.
Chapter 5 Configuring WAN Connections
OL-4015-12