Analog Modem Connection Reference; Analog Modem Welcome - Cisco ROUTER-SDM-CD User Manual

Configuring an Analog Modem Connection
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9

Analog Modem Connection Reference

Analog Modem Welcome

Cisco Router and Security Device Manager 2.5 User's Guide
5-28
In the Create Connection tab, click Analog Modem.
Click Create Connection to start the wizard. The wizard Welcome screen
describes the tasks you will complete.
Click Next to go to the subsequent screens to configure the connection.
Cisco SDM displays the Summary screen when you have completed the
configuration. Review the configuration. If you need to make changes, click Back
to return to the screen in which you need to make changes, then return to the
Summary screen.
If you want to test the connection after sending the configuration to the router,
check Test the connectivity after configuring. After you click Finish, Cisco
SDM tests the connection and displays the test results in another screen.
To send the configuration to the router, click Finish.
The Analog Modem Connection Reference
displays.
Analog Modem Welcome
•
• IP Address: ISDN BRI or Analog Modem
Authentication
•
Dial String
•
Summary
•
This screen describes the tasks you will perform to configure an analog modem
connection. PPP is the only type of encoding supported over an analog modem
connection by Cisco SDM.
Chapter 5 Configuring WAN Connections
describes the screens that Cisco SDM
OL-4015-12