View Defaults - Cisco ROUTER-SDM-CD User Manual

Chapter 11 Site-to-Site VPN
What do you want to do?
If you want to:
Quickly configure a site-to-site VPN
using Cisco SDM-provided defaults.
View the default IKE policy, transform
set, and IPSec rule that will be used to
configure a One-step VPN.
Configure a site-to-site VPN using
parameters that you specify.

View Defaults

OL-4015-12
Do this:
Check Quick setup, and then click Next.
Cisco SDM will automatically provide a default
govern authentication, a default transform set to control the
encryption of data and a default IPSec rule that will encrypt
all traffic between the router and the remote device.
Quick setup is best used when both the local router and the
remote system are Cisco routers using Cisco SDM.
Quick setup will configure 3DES encryption if it is supported
by the IOS image. Otherwise, it will configure DES
encryption. If you need AES or SEAL encryption, click
Step-by-step wizard.
Click View Defaults.
Check Step-by-Step wizard, and then click Next.
You can create a custom configuration for the VPN, and use
any of the Cisco SDM defaults that you need.
Step-by-step wizard allows you to specify stronger encryption
than the Quick setup wizard allows.
This window displays the default Internet Key Exchange (IKE) policy, transform
set, and IPSec rule that Cisco SDM will use to configure a Quick Setup site-to-site
VPN. If you need a different configuration than this window shows, check
Step-by-Step wizard so that you can define configuration values.
Cisco Router and Security Device Manager 2.5 User's Guide
Create Site to Site VPN
IKE policy to
11-5