Select Routing Protocol; Routing Information - Cisco ROUTER-SDM-CD User Manual

Chapter 15 DMVPN
IP Address of hub's mGRE tunnel interface

Select Routing Protocol

Note

Routing Information

Please select the version of RIP to enable
OL-4015-12
Enter the IP address of the mGRE tunnel interface on the primary hub. Obtain this
information from the hub administrator.
Use this window to specify how other networks behind your router are advertised
to the other routers in the network. Select one of the following:
EIGRP—Extended Interior Gateway Routing Protocol.
•
OSPF—Open Shortest Path First.
•
RIP—Routing Internet Protocol.
•
Static Routing. This option is enabled when you are configuring a GRE over
•
IPSec tunnel.
RIP is not supported for DMVPN Hub and spoke topology but is available for
DMVPN Full Mesh topology.
Use this window to add or edit routing information about networks behind the
router that you want to advertise to the other routers in the network. The fields in
this window vary according to the routing protocol specified.
For more information on RIP parameters, see
For more information on EIGRP parameters, see
For more information on OSPF parameters, see
Specify RIP version 1 or version 2.
Cisco Router and Security Device Manager 2.5 User's Guide
Dynamic Multipoint VPN
Add or Edit an RIP Route.
Add or Edit EIGRP
Add or Edit an OSPF
Route.
Route.
15-7