Nhrp Map Configuration - Cisco ROUTER-SDM-CD User Manual

Edit Dynamic Multipoint VPN (DMVPN)
Authentication String
Hold Time
Network ID
Next Hop Server
NHRP Map

NHRP Map Configuration

Cisco Router and Security Device Manager 2.5 User's Guide
15-16
Enter the string that DMVPN hubs
themselves for NHRP transactions. The string can be up to 8 characters long. All
NHRP stations in the DMVPN must be configured with the same authentication
string.
Enter the number of seconds that NHRP network IDs should be advertised as
valid.
Enter the NHRP Network ID. The network ID is a globally unique, 32-bit network
identifier for a nonbroadcast, multiaccess (NBMA) network. The range is 1 to
4294967295. The network ID must be unique for each NHRP station.
This area lists the IP addresses of the next hop servers that this router can contact.
This area must contain the IP address of the primary and secondary hub if this is
a spoke router. If this is a hub, this area must contain the IP addresses of the other
hub routers in the DMVPN.
Click Add to enter the IP address of a next hop server. Select a server, and click
Delete to delete it from the list.
This area lists the available IP-to-NBMA address mappings. Click Add to create
a new map. After you create the map, it will be added to this list. Click Edit to
modify a selected map. Click Delete to remove a selected map configuration.
Use this window to create or edit a mapping between IP and NBMA addresses.
and spokes must use to authenticate
Chapter 15 DMVPN
OL-4015-12