Configuring An Aux Backup Connection; Aux Backup Connection Reference - Cisco ROUTER-SDM-CD User Manual

Configuring an Aux Backup Connection

Configuring an Aux Backup Connection
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9

Aux Backup Connection Reference

Cisco Router and Security Device Manager 2.5 User's Guide
5-24
Complete these steps to configure an Aux Backup connection:
If you want to review the IOS CLI commands that you send to the router when
you complete the configuration, go to the Cisco SDM toolbar, and click Edit >
Preferences > Preview commands before delivering to router.
In the Cisco SDM toolbar, click Configure.
In the Cisco SDM taskbar, click Interfaces and Connections.
In the Create Connection tab, click Aux Backup.
Click Create Connection to start the wizard. The wizard Welcome screen
describes the tasks you will complete.
Click Next to go to the subsequent screens to configure the connection.
Cisco SDM displays the Summary screen when you have completed the
configuration. Review the configuration. If you need to make changes, click Back
to return to the screen in which you need to make changes, then return to the
Summary screen.
If you want to test the connection after sending the configuration to the router,
check Test the connectivity after configuring. After you click Finish, Cisco
SDM tests the connection and displays the test results in another screen.
To send the configuration to the router, click Finish.
The Aux Backup Connection Reference
displays.
Aux Backup Welcome Window
•
Backup Configuration
•
Backup Configuration: Primary Interface and Next Hop IP Addresses
•
• Backup Configuration: Hostname or IP Address to Be Tracked
Chapter 5 Configuring WAN Connections
describes the screens that Cisco SDM
OL-4015-12