Filtering Log Entries By Column - Juniper NETWORK AND SECURITY MANAGER 2010.2 - ADMINISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide

Filtering Log Entries by Column

748
Select the following categories: Predefined, Custom, and Screen. Click OK to apply
2.
your changes. The Log Viewer applies the filter to the log entries.
Use the Filter Summary dialog box to select columns on which you want to filter log
entries. To filter on one or more columns:
Select View >Filter Summary.
1.
The Filter Summary dialog box is displayed.
From the Filter Summary dialog box, select a column on which you want to filter log
2.
entries.
Select the filter settings you wish to apply for the specified column, then click OK.
3.
To select additional Log Viewer columns for filtering log entries, repeat Steps 1–3.
4.
Before you exit NSM, save the Filter Summary changes that you made in Log Viewer.
5.
Figure 108 on page 749 shows the Filter Summary dialog box that you would use to
configure filtering by Device family column.
Copyright © 2010, Juniper Networks, Inc.