Selecting Rules; Using Cut, Copy, And Paste On Rules; Using Cut, Copy, And Paste On Rule Fields - Juniper NETWORK AND SECURITY MANAGER 2010.2 - ADMINISTRATION GUIDE REV1 Administration Manual

Table of Contents

Advertisement

Network and Security Manager Administration Guide

Selecting Rules

504
You cannot disable an entire security policy or a rulebase. You can, however, disable
individual rules; for details, see "Disabling a Rule" on page 506.
When you reimport a device that was previously managed by NSM, you must manually
reassign a policy to it. For information about reimporting issues, see "Reimporting
Devices and Security Policies" on page 506.
To select a single rule, click anywhere in the rule. The following sections explain these
rule functions:
Editing Rule Order on page 504
Using Cut, Copy, and Paste on Rules on page 504
Using Cut, Copy, and Paste on Rule Fields on page 504
Deleting a Rule on page 506
Disabling a Rule on page 506
Using Rule Groups on page 506
Editing Rule Order
To change the order of rules in a policy, right-click the No. Column (the first column) of
a rule and select Move Rule Up or Move Rule Down.

Using Cut, Copy, and Paste on Rules

To quickly create multiple rules that use the same basic information, copy and paste the
rule, then change the parameters in each copied rule to make the rule unique (this is
especially useful for rules that contain detailed rule options such as attack protection).
NOTE: When you cut and paste a rule, your preferred ID is retained. However, when you
copy and paste a rule, a new ID is created.
To cut and paste a rule, right-click inside the No. column (the first column) of the rule
and select Edit > Cut. Next, select a rule that is above or below the position you want to
paste the cut rule into, then select Edit > Paste > <above> <below>.

Using Cut, Copy, and Paste on Rule Fields

You can cut, copy, and paste a column field in a rule to other column fields that have the
same context. When you cut or copy a field, you can perform multiple paste operations.
Cut, copy, and paste operations are available for all column fields except rule ID column
fields. The cut operation is not available for generic column fields such as Notification
and Action.
To perform cut, copy, and paste operations on rule fields:
From the policy rule you want to cut or copy from, right-click in the field and select
1.
Edit > Cut or Edit > Copy. When an element in the field is cut, it is replaced by either
"any" or "default", depending on the field.
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Network and security manager 2010.2

Table of Contents