Juniper NETWORK AND SECURITY MANAGER 2010.2 - ADMINISTRATION GUIDE REV1 Administration Manual page 698

Network and Security Manager Administration Guide
648
Table 55: Active VPN Table (continued)
Item Description
VPN Type Type of tunnel: Site-to-site or dial-up.
Policy Id--In/Out A unique identifier specified when the policy was configured.
Status Tunnel status for the active VPN is UP or Down.
Ave Latency Rolling average latency (in milliseconds).
Last Latency Latency for the last ping response.
Availability Percentage of time a tunnel is available over the last 30 samples.
Local GW Id Local gateway ID for the active VPN.
Peer GW Id Peer gateway ID for the active VPN.
Local GW IP Local gateway IP address for the active VPN.
Peer GW IP Peer gateway IP address for the active VPN.
Local Address Local IP address for the security device associated to the active VPN.
Peer Address Peer IP address for the security device connected to the active VPN.
Monitor Monitoring capability status for the VPN: ON or OFF.
IPSec IPSec (IP security) protocol for the active VPN; AH (Authentication Header)
or ESP (Encapsulating Security Payload).
SPI In SPI (Security Parameter Index) key into the active VPN. A value that
identifies a security association (SA).
SPI Out SPI (Security Parameter Index) key out of the active VPN. A value that
identifies an SA.
Encryption Algorithm used when a user encrypts communication between the security
device and the server. Listed as either SDI or DES.
Authentication Second algorithm used for user encrypted communication between the
security device and server.
Key Type of key associated with the VPN: Auto IKE (Internet Key Exchange) or
manual key.
Lifetime P1 Time listed in seconds before re-keying.
Lifetime P2 Time reported in remaining bytes before re-keying. Independent from
Lifetime P1.
Copyright © 2010, Juniper Networks, Inc.