Idp Sensors - Juniper NETWORK AND SECURITY MANAGER 2010.2 - ADMINISTRATION GUIDE REV1 Administration Manual

Copyright © 2010, Juniper Networks, Inc.
Managed, indicating that the device has connected and the management system has
successfully imported the device configuration.
The next step is to verify the imported configuration using the Device Monitor or the
Device Manager. See "Verifying Imported Device Configurations" on page 127 for details.

IDP Sensors

IDP Sensors running versions of the IDP software earlier than 4.0 cannot be imported. If
those Sensors are already being managed by IDP Manager, migrate your IDP Management
Server and the Sensors with it. Refer to the IDP-NetScreen-Security Manager Migration
Guide for more information.
You need to upgrade unmanaged Sensors to 4.0 or later before adding them to NSM.
See the IDP Installer's Guide for more information.
To import an IDP 4.0 device with a known IP address:
From the domain menu, select the domain in which to import the device.
1.
In Device Manager, select Devices.
2.
Click the Add icon and select Device to open the Add Device wizard.
3.
Select Device Is Reachable (default).
4.
Click Next. The Specify Connection Settings dialog box opens.
5.
Enter the following connection information:
6.
Enter the IP Address of the Sensor.
Enter the username of the device administrator.
Enter the password for the device administrator.
Enter the password for the device root user.
NOTE: All passwords handled by NSM are case-sensitive.
Select the connection method (SSH Version 2) and the port number for the
selected service.
Select the Port Number. The default (port 22) is recommended.
Click Next. The Verify Device Authenticity dialog box opens. The device wizard displays
7.
the RSA Key FingerPrint information. To prevent man-in-the-middle attacks, you
should verify the fingerprint using an out-of-band method.
After you have verified the key, click Next to display the autodetect device information.
8.
This action will take a moment.
Verify that the device type, OS version, device serial number, and device mode are
9.
correct. The host name from the device is also discovered. You can change this name
if desired.
Chapter 4: Adding Devices
115