Juniper NETWORK AND SECURITY MANAGER 2010.2 - ADMINISTRATION GUIDE REV1 Administration Manual page 172

Network and Security Manager Administration Guide
122
Configure and Activate the NSM Agent on the Secure Access or Infranet Controller
Device on page 123
Confirm Connectivity and Import the Device Configuration into NSM on page 124
Install and Configure the Secure Access or Infranet Controller Device
Before you can add a Secure Access or Infranet Controller device to NSM, the device
must be installed and configured, and logon credentials for an NSM administrator must
be configured for it. Perform the following steps:
Select System > Network > Overview on the device administrator's console and
1.
ensure that basic connection information is configured on the device (network
interface settings, DNS settings, and password).
Select Authentication > Auth. Servers and enter the username and password of
2.
the NSM administrator in the applicable authentication server.
NOTE: Only password-based authentication servers can be used. One-time password
authentication is not supported.
Select Administrators > Admin Roles and create an NSM agent role.
3.
Select Administrators > Admin Realms and create a new NSM agent administrator
4.
realm for the NSM agent on the device. Use role mapping to associate the NSM agent
role and realm. Do not apply any role or realm restrictions for the NSM agent role or
realm.
NOTE: You cannot use NSM to add or manage a Secure Access device that has Host
Checker policies enabled for an admin user.
For complete details on installing and configuring Secure Access devices, see the Secure
Access Administration Guide.
For complete details on installing and configuring Infranet Controller devices, see the
Unified Access Control Administration Guide.
Add the Device in NSM
To add the device in the NSM UI, follow these steps:
From the domain menu, select the domain in which you want to import the device.
1.
In Device Manager, select Devices.
2.
Click the Add icon and select Device to open the Add Device wizard.
3.
Select Device is Not Reachable, and then click Next.
4.
In the Specify Name, Color, OS Name, Version, and Platform screen:
5.
Enter a name and select a color to represent the device in the UI.
From the OS Name list, select SA for a Secure Access device, or IC for an Infranet
Controller device,
Copyright © 2010, Juniper Networks, Inc.