Figure 59: Template Operations Job Information Dialog Box; Removing Templates With The Template Operations Directive - Juniper NETWORK AND SECURITY MANAGER 2010.2 - ADMINISTRATION GUIDE REV1 Administration Manual

Copyright © 2010, Juniper Networks, Inc.
Report irrelevant template values (optional)—Reports template settings that are
not relevant to the selected device or devices.
Report conflicts with other templates (optional)—Reports settings that conflict
between two or more templates.
Validate (recommended)—Validates the device configuration after appropriate
changes to the templates and the removal of conflicting values (if needed).
Do not select Remove conflicting device values because it might alter device
values.
Click Apply Changes.
9.
Step 2: Review Results in Job Information Dialog Box

Figure 59: Template Operations Job Information Dialog Box

Consult the reports and error messages generated in Step 1. Resolve any conflicts, missing
assignments, or other errors as desired. Repeat steps 1 and 2 until you are satisfied with
your planned changes.
Step 3: Apply Templates and Clear Overrides
This step updates the NSM database, but does not push the new settings to the device.
CAUTION: You can easily reverse adding templates, but there is no automatic way to
restore conflicting device values that have been removed. Be very careful not to remove
values you want to keep.
Repeat the operations specified in Step 1, but specify one of the Add templates buttons.
If desired, also check the Remove conflicting device values check box.

Removing Templates with the Template Operations Directive

To remove one or more templates from one or more devices, follow these steps:
Chapter 5: Configuring Devices
219