Viewing The Device Tunnel Summary; Adding The Vpn Link; Editing Vpns - Juniper NETWORK AND SECURITY MANAGER 2010.2 - ADMINISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide

Adding the VPN Link

Editing VPNs

560
ID/XAuth options for each gateway, right-click the gateway name and configure the
settings as desired.
Overriding VPN Groups
For all VPNs, this displays VPN groups.
Overriding L2TP Settings
For L2TP VPNs, this displays L2TP information for each VPN member. To edit this
information, right-click L2TP entry and configure the settings as desired.

Viewing the Device Tunnel Summary

For route-based and mixed-mode VPNs, you can view the VPN tunnels between each
route-based member, including the source and peer devices, the tunnel interface, zone,
and physical interface.
NOTE: The device tunnel summary does not appear for policy-based VPNs.
You cannot edit the device tunnels from this view; to make overrides to the VPN tunnels,
edit the interface configuration for each device.
After you have reviewed the autogenerated information and made any desired overrides
to the VPN, you must update your managed devices to activate the VPN. By default, the
VPN you created in VPN manager is installed as the first rule in the security policy for
each managed device. However, the security policy does not display the VPN.
You can manually add a VPN link to your security policy; a VPN link creates a link between
the security policy and VPN (the link points to the VPN rules that exist in the VPN in VPN
Manager). You might want to add a VPN link so you can reposition it elsewhere in the
policy, or to make the VPN viewable in your policy.
To create a VPN link, in security policies, select an existing security policy (or create a
new security policy), then right-click and select Add VPN link. Select the VPN name and
click OK to add the link to the policy. By default, the link appears at the top of the policy,
but you can move the VPN link anywhere in the policy, just as you would a firewall rule.
If you make changes to the VPN or create overrides, the VPN link automatically updates
to reflect those edits.
To edit a VPN created with VPN Manager:
In the navigation tree, select VPNs. A table listing all configured VPNs appears in the
1.
main display area.
Right-click the VPN you want to edit and select Edit. The expanded VPN view dialog
2.
box appears.
Make the necessary changes, then click OK to apply your changes.
3.
Copyright © 2010, Juniper Networks, Inc.