Juniper NETWORK AND SECURITY MANAGER 2010.2 - ADMINISTRATION GUIDE REV1 Administration Manual page 183

Copyright © 2010, Juniper Networks, Inc.
After NSM autodetects the device, click Next to activate the device in NSM.
5.
Click Update Now to update the configuration on the device with the settings from
6.
the modelled device.
If you do not update the configuration now, you will have to do it manually later by
right-clicking the device and selecting Update Device.
The Job Information box displays the job type and status for the update. When the
job status displays successful completion, click Close.
After the update finishes, the device status displays as "Managed", indicating that the
device has connected and the management system has successfully pushed the device
configuration.
IDP Sensors
To activate an IDP Sensor with a static IP address:
Check the device configuration status by holding your mouse cursor over the device
1.
in Device Manager (you can also check configuration status in Device Monitor). The
device configuration status should display "Modeled", indicating that the management
system is waiting for the device to be activated.
Right-click the device and select Activate Device to display the Activate Device
2.
wizard.
Select Device deployed and IP is reachable.
3.
Click Next. The Specify Connection Settings dialog box opens. Enter the connection
4.
information:
Enter the IP Address of the device.
Enter the device administrator name.
Enter the device administrator password.
Enter the device root password.
NOTE: All passwords handled by NSM are case-sensitive.
Set the connection method to SSH Version 2.
Click Next to display the Verify Device Authenticity dialog box.
5.
Click Next.
6.
After NSM autodetects the device, click Next to activate the device in NSM.
7.
Click Update Now to update the configuration on the device with the settings from
8.
the modelled device.
If you do not update the configuration now, you will have to do it manually later by
right-clicking the device and selecting Update Device.
Chapter 4: Adding Devices
133