Juniper NETWORK AND SECURITY MANAGER 2010.2 - ADMINISTRATION GUIDE REV1 Administration Manual page 279

Copyright © 2010, Juniper Networks, Inc.
in the configuration group. The following table shows the MTU values assigned by each
mechanism in this example, and the final outcome in the device itself.
Value Set in
Configuration Group
by Wildcard
Interface Name Order of increasing precedence —>
3K
fe-0/0/0
3K
fe-0/0/1
3K
fe-0/0/2
All other 3K
interfaces
To create this configuration, follow these steps:
Create a template containing a configuration group that will apply an MTU value of
1.
3K to all devices to which the configuration group is applied:
In the Device Manager, select Device Templates.
a.
Click the Add icon and select JUNOS Template.
b.
From the JUNOS Product Series list, select JUNOS J Series to create a new
c.
template for J Series devices.
Click Next and then Finish to create a new template for J Series devices.
d.
In the Name field, enter a new name for the template, for example, set-mtu.
e.
Open the template by double-clicking it in the Device Template window, and enter
2.
the following information:
In the Configuration tab of the new template, select Config Group List.
a.
Click the Add icon and select Regular from the list.
b.
In the New dialog box, name the new group, for example, group1.
c.
Expand Interfaces, select Interface, and click the Add icon.
d.
Name the interface with the wildcard character by typing <*> in the Name field.
e.
NOTE: Be sure to include the angle brackets, because they are required by the JUNOS
syntax.
Chapter 5: Configuring Devices
Value Set in
Value Set in Regular
Template configuration
6K 5K
4K
Final
Value
Applied to
Device
5K
4K
3K
3K
229