Table of Contents
Advertisement
Copyright © 2010, Juniper Networks, Inc.
Trust-Untrust Port Mode
Trust-Untrust mode is the default port mode. See Figure 25 on page 105 for port, interface,
and zone bindings.
Figure 25: Trust-Untrust Port Mode Bindings
This mode provides the following bindings:
Binds the Untrusted Ethernet port to the Untrust interface, which is bound to the Untrust
security zone.
Binds the Modem port to the serial interface, which you can bind as a backup interface
to the Untrust security zone.
Binds the Ethernet ports 1 through 4 to the Trust interface, which is bound to the Trust
security zone.
Home-Work Port Mode
Home-Work mode binds interfaces to the Untrust security zone and to Home and Work
security zones. The Home and Work zones enable you to segregate users and resources
in each zone. In this mode, default policies permit traffic flow and connections from the
Work zone to the Home zone, but do not permit traffic from the Home zone to the Work
zone. By default, there are no restrictions for traffic from the Home zone to the Untrust
zone. See Figure 26 on page 105 for port, interface, and zone bindings.
Figure 26: Home-Work Port Mode Bindings
This mode provides the following bindings:
Chapter 4: Adding Devices
105
Advertisement
Table of Contents
Related Manuals for Juniper NETWORK AND SECURITY MANAGER 2010.2 - ADMINISTRATION GUIDE REV1
Related Products for Juniper NETWORK AND SECURITY MANAGER 2010.2 - ADMINISTRATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.3 - CONFIGURING INTRUSION DETECTION AND PREVENTION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - API GUIDE REV 1
- Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING J SERIES SERVICES ROUTERS AND SRX SERIES SERVICES GATEWAYS GUIDE REV
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - NSMXPRESS SERIES II REV 1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1
- Juniper NETWORK AND SECURITY MANAGER 2010.3
- Juniper MEDIA FLOW CONTROLLER 2.0.4 -
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - AQL EVENT AND FLOW QUERY CLI GUIDE
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - EVENT CATEGORY CORRELATION REV 1
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - SNMP AGENT GUIDE REV 1
- Juniper STRM LOG MANAGEMENT 2008.2 - S 6-2008
Need help?
Do you have a question about the NETWORK AND SECURITY MANAGER 2010.2 - ADMINISTRATION GUIDE REV1 and is the answer not in the manual?
Questions and answers