Table of Contents
Advertisement
Copyright © 2010, Juniper Networks, Inc.
Figure 58: Select Template Dialog Box
After you have selected templates, click OK. You can use the up and down arrow buttons
in the main dialog box to order the selected templates as you wish.
Template Operation Section
The next section features four buttons:
Add templates with lowest priority—Adds the templates to each device's template
list with the lowest priority. Added templates will be lower priority than templates
previously assigned to the device. Templates with higher priority can override the values
applied by these templates.
Add templates with highest priority—Adds the templates to each device's template
list with highest priority. Added templates will be higher priority than templates
previously assigned to the device. Values in these templates will override values applied
by lower-priority templates.
Remove templates—Removes all selected templates from each selected device.
Don't change templates—Makes no changes to devices in the database. This setting
is useful if you want to perform a validation, run a report, or clear overrides without
changing the template assignments.
Options Section
The last section provides optional operations:
Remove conflicting device values—Overrides any device settings that override template
values provided by the selected templates. Normally, template values do not override
manually set values.
Report irrelevant template values—Reports any values that are set in templates but
that are not used on the selected devices. A template might provide values for features
Chapter 5: Configuring Devices
217
Advertisement
Table of Contents
Related Manuals for Juniper NETWORK AND SECURITY MANAGER 2010.2 - ADMINISTRATION GUIDE REV1
Related Products for Juniper NETWORK AND SECURITY MANAGER 2010.2 - ADMINISTRATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.3 - CONFIGURING INTRUSION DETECTION AND PREVENTION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - API GUIDE REV 1
- Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING J SERIES SERVICES ROUTERS AND SRX SERIES SERVICES GATEWAYS GUIDE REV
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - NSMXPRESS SERIES II REV 1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1
- Juniper NETWORK AND SECURITY MANAGER 2010.3
- Juniper MEDIA FLOW CONTROLLER 2.0.4 -
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - AQL EVENT AND FLOW QUERY CLI GUIDE
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - EVENT CATEGORY CORRELATION REV 1
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - SNMP AGENT GUIDE REV 1
- Juniper STRM LOG MANAGEMENT 2008.2 - S 6-2008
Need help?
Do you have a question about the NETWORK AND SECURITY MANAGER 2010.2 - ADMINISTRATION GUIDE REV1 and is the answer not in the manual?
Questions and answers