Table of Contents
Advertisement
Copyright © 2010, Juniper Networks, Inc.
e.
In the General Properties screen, enter untrust in the Name field.
f.
In the zone navigation tree, select Screen > Denial of Service Defense. The
Denial of Service Defense screen appears. Select and set the Source IP Based
Session Limit Threshold to 256.
Your settings appear as shown in Figure 49 on page 205.
Figure 49: Configure DoS Defense Settings for the DoS2 Template
Click OK in the New — Predefined Zone dialog box, and then click OK in the New
Device Template configuration dialog box.
Apply the DoS2 template to the NetScreen-208 device:
5.
a.
In the navigation tree, select Device Manager > Devices. Double-click the
NetScreen-208 device icon to open the Device dialog box.
b.
Select Info > Templates in the device navigation tree. Click the Edit icon in the
Templates configuration screen. The Edit Templates dialog box appears.
c.
Select the DoS2 template (and keep the DoS template selected).
d.
Click OK in the Edit Templates dialog box.
Set the template priority.
6.
Currently, the DoS2 template has the higher priority, which enables it to override any
similar values set by the DoS template, as shown in Figure 50 on page 206. The DoS2
template overrides similar values set in the DoS template.
Chapter 5: Configuring Devices
205
Advertisement
Table of Contents
