Logging Console; Logging Host; Logging Host Remove - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

15.3.3 logging console

This command enables logging to the console. You can specify the
value as either an integer from 0 to 7 or symbolically through one of the following
keywords:
emergency
informational
Default
Format
Mode
15.3.3.1 no logging console
This command disables logging to the console.
Format
Mode

15.3.4 logging host

This command enables logging to a host. You can configure up to eight hosts. The
is the IP address of the logging host. The
<ipaddr>
to 65535. You can specify the
symbolically through one of the following keywords:
(2), (3),
error
Default
Format
Mode

15.3.5 logging host remove

This command disables logging to host. See
page 15-26 for a list of host indexes.
Format
Mode
System Maintenance Commands
(0), (1),
alert
(6), or (7).
debug
disabled; critical
logging console [severitylevel]
Global Config
no logging console
Global Config
<severitylevel>
(4), (5),
warning notice
port - 514; level - critical;
logging host <ipaddr> [<port>][<severitylevel>]
Global Config
logging host remove <hostindex>
Global Config
v1.0, February 2007
(2), (3),
critical error
<port>
value as either an integer from 0 to 7 or
emergency
(6), or
informational
Section 15.3.11 "show logging hosts" on
<severitylevel>
(4),
warning notice
value is a port number from 1
(0), (1),
alert critical
(7).
debug
(5),
15-23