Table of Contents
Advertisement
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
ip rip receive version
This command configures the interface to allow RIP control packets of the specified version(s) to
be received.
The value for <mode> is one of: rip1 to receive only RIP version 1 formatted packets, rip2 for RIP
version 2, both to receive packets from either format, or none to not allow any RIP control packets
to be received.
Default
Format
Mode
no ip rip receive version
This command configures the interface to allow RIP control packets of the default version(s) to be
received.
Format
Mode
ip rip send version
This command configures the interface to allow RIP control packets of the specified version to be
sent.
The value for <mode> is one of: rip1 to broadcast RIP version 1 formatted packets, rip1c (RIP
version 1 compatibility mode) which sends RIP version 2 formatted packets via broadcast, rip2 for
sending RIP version 2 using multicast, or none to not allow any RIP control packets to be sent.
Default
Format
Mode
no ip rip send version
This command configures the interface to allow RIP control packets of the default version to be
sent.
Format
Mode
9-30
both
ip rip receive version {rip1 | rip2 | both | none}
Interface Config
no ip rip receive version
Interface Config
rip1c
ip rip send version {rip1 | rip1c | rip2 | none}
Interface Config
no ip rip send version
Interface Config
202-10009-01_060204
Routing Commands
Advertisement
Table of Contents
