Ip Routing; Ip Address; Ip Route - NETGEAR GSM7224R - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200R Series Layer-2 Switches with Static

14.2.2 ip routing

This command enables the IP Router Admin Mode for the master switch.
Format
Mode
14.2.2.1 no ip routing
This command disables the IP Router Admin Mode for the master switch.
Format
Mode

14.2.3 ip address

This command configures an IP address on an interface. You can also use this command to
configure one or more secondary IP addresses on the interface.
The value for
The value for
subnet mask of the interface. This changes the label IP address in
Format
Mode
14.2.3.1 no ip address
This command deletes an IP address from an interface. The value for
Address of the interface. The value for
which represents the Subnet Mask of the interface.
Format
Mode

14.2.4 ip route

This command configures a static route. The
<subnetmask>
hop router.
14-8
ip routing
Global Config
no ip routing
Global Config
is the IP Address of the interface.
<ipaddr>
is a 4-digit dotted-decimal number which represents the
<subnetmask>
ip address <ipaddr> <subnetmask> [secondary]
Interface Config
no ip address <ipaddr> <subnetmask> [secondary]
Interface Config
is a valid subnet mask. The
v1.0, November 2007
is a 4-digit dotted-decimal number
<subnetmask>
is a valid ip address. The
<ipaddr>
is a valid IP address of the next
<nextHopRtr>
.
show ip interface
is the IP
<ipaddr>
Routing Commands