Draytek Vigor2136 Series User Manual page 198

If MAC Allow/Block List Only is selected as the Access Control Mode.
Set up MAC Address
Filter by
If Login with built-in User function is selected as the Access Control Mode
Authentication Mode
Set up MAC Address
Filter by
User
User Groups
before accessing the network.
Guest Hotspot - Allow or deny the clients/user accounts access to the
network based on the hotspot profile selected.
MAC Address Filter
Selecting from Profile – Use pre-defined MAC Filtering profiles as the
filtering basis.
MAC Filtering Profile - Select one of the MAC filtering profiles

(Security>>MAC Filtering Profile) as the filtering basis.
Manually – Define the MAC addresses and separate them as Allow
List or Block List.
MAC Address Filter Mode – Select Allow List (allow the clients to

access) or Block List (deny the clients access). Then, enter the
MAC address of the clients separately on the MAC Address Filter
Table.
MAC Address Filter Table – Click +Add to enter the MAC address

of the client.
Single-Factor - Only identification authentication is required.
Multi-Factor - Multi-Factor authentication adds an extra layer of
security, ensuring that only those users or devices within the Users or
VLAN that apply specified Group Policy can access the specified
resource.
MAC Address Filter
Selecting from Profile – Use pre-defined MAC Filtering profiles as the
filtering basis.
MAC Filtering Profile - Select one of the MAC filtering profiles

(Security>>MAC Filtering Profile) as the filtering basis.
Manually – Define the MAC addresses and separate them as Allow
List or Block List.
MAC Address Filter Mode – Select Allow List (allow the clients to

access) or Block List (deny the clients access). Then, enter the
MAC address of the clients separately on the MAC Address Filter
Table.
MAC Address Filter Table – Click +Add to enter the MAC address

of the client.
Allowed User List
Configure the whitelist settings. Users are allowed to send and receive
traffic that satisfies whitelist settings.
All Users – All user accounts will be considered part of the whitelist.
Selected Users – The whitelist will only consider the user accounts
that have been selected.
None - There will be no user account applied.
Configure the whitelist settings. Groups are allowed to send and
receive traffic that satisfies whitelist settings.
All Groups – All user groups will be considered part of the whitelist.
Selected Groups – The whitelist will only consider the user groups
that have been selected.
188