Advertisement
Connectors
Interface
Factory Reset
Restore the default settings.
Usage: Turn on the router (ACT LED is blinking). Press the hole and keep for
more than 5 seconds. When you see the ACT LED begins to blink rapidly
than usual, release the button. Then the router will restart with the factory
default configuration.
2.5G WAN
Connector for remote networked devices (by Ethernet cable).
P1~P4
Connectors for local networked devices.
In which the transmission rate for P1(only) can reach 2.5G.
USB1~USB2
Connector for a USB device (USB Modem or printer).
ON/OFF
Power switch.
PWR
Connector for a power adapter.
Note
Remove the protective film from the router before use to ensure ventilation.
Explanation
2
Advertisement
Need help?
Do you have a question about the Vigor2136 Series and is the answer not in the manual?
Questions and answers