Table of Contents
Advertisement
User Guide
RAID Configuration using the SCSISelect Utility
Installing the Hard Disk Drives
Install the required SCSI hard disk drives to your system.
■
Use two hard disk drives of the same revolution (rpm).
■
To configure RAID 1, use also two hard disk drives of the
same capacity.
Enabling the RAID Feature using the SCSISelect Utility
Two or more of the installed hard disk drives can be used either as a single disk or a
RAID drive.
a single disk drive.
To configure a disk drive connected to the onboard SCSI connector with the
SCSISelect Utility:
1. Start the SCSISelect Utility. See
page
Note: The factory-set value is to use the hard disk drive as
168.
AIC-7902 A at Slot 23 02:03:00
AIC-7902 B at Slot 23 02:03:01
Caution
"Running the SCSISelect Utility" on
103
www.nec-computers.com
Advertisement
Table of Contents
