Pci Configuration Status And Error Messages - NEC POWERMATE PRO150 Manual

PCI Configuration Status and Error Messages

The following PCI messages are displayed as a group with bus, device and
function information.
Message
Bad PnP Serial ID Checksum
Floppy Disk Controller Resource Conflict
NVRAM Checksum Error, NVRAM
Cleared
NVRAM Cleared By Jumper
NVRAM Data Invalid, NVRAM Cleared
Parallel Port Resource Conflict
PCI Error Log is Full
PCI I/O Port Conflict
PCI IRQ Conflict
PCI Memory Conflict
Primary Boot Device Not Found
Primary IDE Controller Resource Conflict
PowerMate Pro150 System
Explanation
The Serial ID checksum of a Plug and Play
card was invalid.
The floppy disk controller has requested a
resource that is already in use.
The ESCD data was reinitialized because
of an NVRAM checksum error. Try
rerunning the ICU.
The "Clear CMOS" jumper has been moved
to the "Clear" position and CMOS RAM has
been cleared.
Invalid entry in the ESCD.
The parallel port has requested a resource
that is already in use.
This message is displayed when more than
15 PCI conflict errors are detected. No
additional PCI errors can be logged.
Two devices requested the same resource,
resulting in a conflict.
Two devices requested the same resource,
resulting in a conflict.
Two devices requested the same resource,
resulting in a conflict.
The designated primary boot device (hard
disk drive, diskette drive, or CD-ROM drive)
could not be found.
The primary IDE controller has requested a
resource that is already in use.
Continued
6
-15