Installing The Standard Cutter - Printronix SL5000E series User Manual

Printronix sl5000e: users manual

Hide thumbs Also See for SL5000E series:

Table of Contents

Installing The Standard Cutter

RJ-11 Receptacle

(Not visible in this

1. Loosen the knurled thumbscrew on the front of the cutter and swing open

the cutter assembly from the cutter assembly mounting bracket.

2. Place the cutter assembly in position.

3. Install the two screws using the appropriate metric hex key.

4. Plug the RJ-11 connector into the RJ-11 receptacle.

5. Place the cutter assembly into the up (closed) position and secure it by

tightening the knurled thumbscrew.

Cutter Assembly

Figure 2. Standard Cutter Assembly

Lower Support Assembly

Mounting Bracket

Table of Contents

T5000e series