Restore The Printer To Operation - Printronix SL5000E series User Manual

Restore The Printer To Operation

1. Set the printer power switch to | (ON).
. .
2. Press to place the printer in Menu Mode.
.
3. Press the ↓ and ↵ keys at the same time until "ENTER SWITCH
UNLOCKED" appears on the printer display.
. .
4. Press until "PRINTER CONTROL" displays.
.
5. Press ↑ until "Admin User" displays.
6. Press + or - until "Enable" displays.
7. Press ↵ to select the "Enable" option. An asterisk (*) appears next to
"Enable."
. .
8. Press until "MEDIA CONTROL" displays.
.
9. Press ↓ until "Media Handling" displays.
10. Press + or - until "Cut" displays.
11. Press ↵ to select "Cut." An asterisk (*) displays next to "Cut."
12. Press ↓ until "Cutter Type" displays.
13. Press + or - until "Standard" displays.
14. Press ↵ to select "Standard." An asterisk (*) displays next to "Standard."
15. Relock the ↵ key by pressing ↓ and ↵ at the same time, then press
PAUSE to put the printer back online.
16. If the bar code validator is installed, adjust the validator beam. (Refer to
"VALIDATOR" on page 108.)
17. Make sure any media sticking out of the platen goes in the cutter entrance
slot.
18. Test the printer cutting operation and print quality by selecting the
Diagnostics → Printer Tests menu and printing one of the test patterns.
(Refer to "DIAGNOSTICS" on page 249.)
19. To save the configuration parameters, refer to "Saving A Configuration"
on page 84.
Restore The Printer To Operation
357