Wireless Address Submenus - Printronix SL5000E series User Manual

WIRELESS ADDRESS Submenus

WIRELESS ADDRESS Submenus
IP Address
This item allows you to set the IP Address for the TCP/IP protocol in four
three-digit segments (SEG1 through SEG4). If the IP Address is assigned by
Bootp, ARP or DHCP, it is dynamic and read-only.
The factory defaults for the SEG1 through SEG4 are 000, 000, 000, and 000.
When changing the IP Address, the printer resets the Network Interface Card
(NIC) when the printer is placed online. When the printer resets the NIC, the
LCD displays DO NOT POWER OFF. After the NIC has completed its
initialization, the LCD displays E-NET INIT to signal that the NIC and printer
are in the initialization process. When both the NIC and printer have
completed initialization, the LCD displays E-NET READY.
Subnet Mask
This item allows you to set the Subnet Mask for the TCP/IP protocol in four
three-digit segments (SEG1 through SEG4). If the Subnet Mask is assigned
by Bootp, Arp or DHCP, it is dynamic and read-only.
The factory defaults for the SEG1 through SEG4 are 000, 000, 000, and 000.
When changing the Subnet Mask, the printer resets the NIC when the printer
is placed online. When the printer resets the NIC, the LCD displays DO NOT
POWER OFF. After the NIC has completed its initialization, the LCD displays
E-NET INIT to signal that the NIC and printer are in the initialization process.
When both the NIC and printer have completed initialization, the LCD displays
E-NET READY.
Gateway Address
This item allows you to set the Gateway Address for the TCP/IP protocol in
four three-digit segments (SEG1 through SEG4). If the Gateway Address is
assigned by Bootp, ARP or DHCP, it is dynamic and read-only.
The factory defaults for the SEG1 through SEG4 are 000, 000, 000, and 000.
When changing the Gateway Address, the printer resets the NIC when the
printer is placed online. When the printer resets the NIC, the LCD displays DO
NOT POWER OFF. After the NIC has completed its initialization, the LCD
displays E-NET INIT to signal that the NIC and printer are in the initialization
process. When both the NIC and printer have completed initialization, the
LCD displays E-NET READY.
273