Printronix SL5000E series User Manual page 392

PWR SUPPLY HOT fault message, 333
Pwr Up Auto-Cal option, 137
Q
QUICK SETUP
menu, 100
submenus, 101
Quiet Zones option, 112
R
RAM Disk Size option, 150
Rbn Takeup Full option, 131
RBN TAKEUP FULL Remove Used Rbn fault
message, 334
REACTIVATING HOST SERIAL fault
message, 334
Received Data (RD) signal
RS-232 serial interface, 306
RS-422 serial interface, 306
RECHARGE BATTERY fault message, 334
Remove Label fault message, 334
Removing media from the rewinder, 61
Removing the media guide, 65
Renew Life (SEC) option, 285
Renew Life Units option, 285
Repeat Form Opt option, 233
Report Status option (C/T Port), 266
Report Status option (Parallel Port), 255
Report Status option (Serial), 261
Request To Send (RTS) signal, RS-232 serial
interface, 306
Request to Send option, 262
Reset Cfg Names option, 117
Reset Cmd CFG Ld option, 234
Reset Head Data option, 252
Reset Kerb. Pwd option, 284
Reset SSID Name option, 280
Reset WEP Keys option, 282
RESETTING PLEASE WAIT fault message, 334
Resistors, configuration, 305
Resolution Mode option, 234
Resp. Polarity option, 256
RESTORING BOOT CODE fault message, 334
Rewinder, 25, 345
392
removing printed media from, 61
using, 56
RFID MAX RETRY Check System fault message,
335
RFID TAG FAILED Check Media fault message,
334
Ribbon, 28
loading, 40, 53
Printronix, 348
Ribbon 8300, 348
Ribbon 8500, 348
Ribbon 8550, 348
Ribbon 8600, 348
Ribbon 8700, 348
Ribbon 8770, 348
specifications, 340
RIBBON BROKEN Reload Ribbon fault
message, 335
RIBBON FAULT Timeout fault message, 335
RIBBON LOAD BAD Reload Ribbon fault
message, 335
Ribbon Low fault message, 335
Ribbon Low option, 131
RIBBON OUT Load Ribbon fault message, 335
Ribbon specifications, 340
Ribbon Width option, 131
Right Margin option, 234
Right pressure block, 67
Roll media, 41
Rot. Char Size option, 234
RS-232 serial interface
Clear To Send (CTS), 306
Data Carrier Detect (DCD), 306
Data Set Ready (DSR), 306
Received Data (RD), 306
Request To Send (RTS), 306
Transmitted Data (TD), 306
RS-422 serial interface
received data (RD), 306
transmitted data (TD), 306
Running auto calibrate, 74
Running manual calibrate, 77
Running media profile, 75