Printronix SL5000E series User Manual page 244

Chapter 3
Emulation Submenus
•
Only With PDF. UPC/EAN bar codes are printed with descenders only
when the PDF command is presented.
The factory default is Always.
UPC Descenders (VGL)
(From page 178.)
•
Enable. UPC/EAN bar codes are printed with descenders, even if there is
no human readable data.
•
Disable. UPC/EAN bar codes are printed without descenders if there is
no human readable data.
The factory default is Enable.
Upr. Case Select
(From page 188.) Controls how the printer handles lowercase characters it
receives from the host computer. When enabled, all characters are printed in
uppercase.
•
Disable. Prints lowercase characters received from the host computer as
lowercase; prints uppercase characters received from the computer as
uppercase.
•
Enable. Prints lowercase characters received from the host computer as
their corresponding uppercase equivalents; prints uppercase characters
received from the computer as uppercase.
The factory default is Disable.
User-Def Ratio
(From page 176.) This option allows you to ignore the user-defined barcode
ratio and replace it with the default ratio (X1).
•
Enable. Allows the user-defined barcode ratio.
•
Disable. The user-defined barcode ratio will be replaced with the default
ratio (X1).
The factory default is Enable.
User-Defined St1 (Start Code 1)
(From page 159, page 161, page 164, page 165, page 171, page 173.) This
option allows you to define your own value (in ASCII characters) for the User
Defined option in the Lead-in Chars menu. "St1" specifies Start Code 1. See
"Lead-in Chars" on page 226 for additional information.
The range is 40 - FF, and the factory default is 5F.
244