Do Ff At Tof - Printronix SL5000E series User Manual

•
CR = CR + LF. Inserts an extra line feed after each carriage return. The
next print position will be print position 1 of the next line.
The factory default is CR = CR.
Define LF code (PGL, Serial Matrix, Proprinter XL, Epson FX)
(From page 175, page 190, page 192, page 194.) This parameter forces the
printer to insert an automatic Carriage Return code into the data stream
whenever a Line Feed code occurs. This can be used in most installations,
but it is required if the host computer does not send carriage returns to the
printer.
NOTE: For this menu to take effect in PGL, PGL Normal needs to be set to
PGL Menu (see page 176).
•
LF = LF. Does not perform an automatic carriage return. The next print
position will be at the current print character position on the next line.
•
LF = CR + LF. Performs an automatic carriage return. The next print
position will be print position 1 of the next line.
The factory default is LF = LF.
Define LF code (P-Series, P-Series XQ)
(From page 185, page 187.)
•
LF = CR + LF. Forces an automatic carriage return with each Line Feed
command received. The next print position is position 1 of the next line.
•
LF = LF. Does not perform an automatic carriage return when a Line Feed
command is received. The next print position will be the current print
position on the next line.
The factory default is LF = CR + LF.
Delimiter
(From page 181.) This item allows you to select the delimiter used to separate
the parameter of a command.
The range is 1-255, and the factory default is 44.

Do FF at TOF

(From page 176.) Determines whether the printer, with media already set at
the TOF (Top-of-Form) position, will advance media to the next TOF position
upon receipt of an FF command.
•
Enable. The printer will advance media from the present TOF position to
the next TOF position upon receipt of an FF command, causing a blank
form.
•
Disable. The printer will not advance media from the present TOF
position to the next TOF position upon receipt of an FF command.
The factory default is Enable.
Overview
211