Ethernet Speed; Job Control - Printronix SL5000E series User Manual

Ethernet Speed

This menu appears only if a 10/100Base-T Network Interface Card (NIC) is
installed.
The Ethernet Speed menu has five different speed modes to allow
compatibility with different systems and networks:
•
Auto Select. Tells the 10/100Base-T NIC to perform an auto detection
scheme and configure itself to be 10 Half Duplex, 10 Full Duplex, 100 Half
Duplex, or 100 Full Duplex.
•
10 Half Duplex. Tells the 10/100Base-T NIC to communicate at 10
Megabits per second using half duplex.
•
10 Full Duplex. Tells the 10/100Base-T NIC to communicate at 10
Megabits per second using full duplex.
•
100 Half Duplex. Tells the 10/100Base-T NIC to communicate at 100
Megabits per second using half duplex.
•
100 Full Duplex. Tells the 10/100Base-T NIC to communicate at 100
Megabits per second using full duplex.
The factory default is Auto Select.

Job Control

•
Standard. The NIC waits for the entire job to be received before it
indicates the job is done.
•
Enhanced. The NIC waits for the entire job to be printed before it
indicates the job is done.
•
Off. There is no synchronization between the NIC and the printer.
The factory default is Standard.
NOTE: For detailed information about using the NIC, refer to the Network
Interface Card User's Manual .
ETHERNET PARAMS Submenus
271